[SCRIPT] fr34k's macOS-eGPU.sh - one script, all solutions, fully automated
@fr34k, nothing to apologize. You have limited time and I appreciate your efforts.
First, this script is really good, not clunky, and at the end I could uninstall, so don't worry. Everything is OK.
Sad thing is, I hope I will not use it in a long time as I changed to AMD. Tomorrow I will receive my new card.
Thanks for your hard work!!!
I'm running 10.13.6 (17G4015) and I get the "Your system has not yet been approved" message...am I reading your post correctly in assuming that the script does not yet work on any 10.13.6 installations newer than build 17G65??
If that's the case, I don't have a problem backing things up and doing a fresh OS install if it means getting my Nvidia card to work.
Thank you again for all your hard work!!
Thank you for responding. Went to page 20 and found the solution. Script seems to have run perfectly and it downloaded the Nvidia drivers and they were installed, and while macOS is recognizing the AORUS Gaming Box...it's not recognizing the GTX 1070 card that's inside it.
I haven't understood how to -uninstall from the old goalque osx 10.12 automate-eGPU.sh script once I've installed High Sierra. I do not understand the instructions I have found so far or they don't seem to work the way I'm doing them.
I just bought a MSI Rx560 for my AORUS Gaming Box 1080 Eclosure and my laptop is 2016 MBP13 with Macos 10.14.2 Mojave. I tried @goalque 's automate-eGPU.kext, but it still showed this error after fixing permissions by using "Kext Utility":
/Library/Extensions/automate-eGPU.kext failed to load - (libkern/kext) authentication failure (file ownership/permissions); check the system/kernel logs for errors or try kextutil(8).
@its_dy1an Software tab of the forum.